After I cleaned up the files produced by Pepakura with Illustrator I could test the prototype.
If you look closely to the previous post about this project, you see that I don’t have a screenshot from the rounded part on top of the can. This is because I couldn’t get it to work in Google Sketchup… So I decided to make a globe in 3d, make a flat version in Pepakura and edit it in Illustrator (cut parts away I don’t need).
Here a the different parts I tested:
The tube
The can
The cap
The round part of the can…
I don’t think I will be using this part: it’s to detailed for this project. And quite difficult to make, when printed on a A4 papersheet.
The Spraycan complete
So without the curved part, this will be the look.
2 replies on “Papercraft prototype: Spraycan – part 4”
Eén twee drie vier, spuitbus van, spuitbus van
Eén twee drie vier, spuitbus van papier.
Als de spuitbus dan niet past,
Zet ‘m in de glazenkast.
Eén twee drie vier, spuitbus van papier.
😀